Show simple item record

dc.contributor.authorCasetta, Douglas
dc.date.accessioned2020-04-29 19:42:33 (GMT)
dc.date.available2022-04-30 04:50:04 (GMT)
dc.date.issued2020-04-29
dc.date.submitted2020-04-20
dc.identifier.urihttp://hdl.handle.net/10012/15798
dc.description.abstractIn recent years, interest in renewable, environmentally friendly and low-cost materials has grown and has become a global trend. In view of the high consumption of petrochemical plastics that use reinforcing agents such as talc, calcium carbonates, and synthetic fibers to improve their performance, there is an opportunity for cellulose fibers to replace these materials. Cellulose fibers mainly meet this need, as they have very good mechanical properties, low density, high specific resistance, non-abrasive, renewable, ecological and biodegradability characteristics. Cellulose fiber is produced mainly for the paper and packaging industry. However, cellulose fiber available in regular processes is not suitable for polymer composites because it is highly aggregated. Most studies in literature about cellulose dewatering (filtration) are based on batch processes. To the best of our knowledge, there are no studies in the literature about continuous dewatering (filtration) of cellulose with additives suitable for polymer composites. For this reason, this work studied the variables in a continuous filtration process (rotating drum) that affect the dehydration (filtration rate) of the mixture of cellulose and additives for polymer composites applications. It also correlated the process variables and formulation with the dispersion of cellulose fibers in the polymer matrix and the performance of the polymer composites. The results showed that vacuum pressure and consistency were the parameters with higher influence in the quality of the cake. The addition of PP fibers and surfactant reduced the aggregation of cellulose fibers allowing to produce injection moulded samples without the need of pre-extrusion. The composites produced via direct injection moulding (without pre-extrusion) showed similar results to the ones produced using the traditional method (extrusion followed by injection moulding) with substantial increase in stiffness and a small reduction in the impact strength.en
dc.language.isoenen
dc.publisherUniversity of Waterlooen
dc.subjectdispersion of cellulose fibers,en
dc.subjectpolypropylene and cellulose fibersen
dc.subjectlab scale rotary drum filtration systemen
dc.subjectcontinuous filtration processen
dc.subjectdewateringen
dc.titleEnhanced Cellulose Fiber for Polymer Compositesen
dc.typeMaster Thesisen
dc.pendingfalse
uws-etd.degree.departmentChemical Engineeringen
uws-etd.degree.disciplineChemical Engineeringen
uws-etd.degree.grantorUniversity of Waterlooen
uws-etd.degreeMaster of Applied Scienceen
uws-etd.embargo.terms2 yearsen
uws.contributor.advisorSimon, Leonardo
uws.contributor.affiliation1Faculty of Engineeringen
uws.published.cityWaterlooen
uws.published.countryCanadaen
uws.published.provinceOntarioen
uws.typeOfResourceTexten
uws.peerReviewStatusUnrevieweden
uws.scholarLevelGraduateen


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record


UWSpace

University of Waterloo Library
200 University Avenue West
Waterloo, Ontario, Canada N2L 3G1
519 888 4883

All items in UWSpace are protected by copyright, with all rights reserved.

DSpace software

Service outages