Solid Phase Microextraction as a Sample Preparation Tool for Targeted and Untargeted Analysis of Biological Matrices
MetadataShow full item record
Successful determination of small molecules in complex biological systems requires implementation of robust analytical methodologies able to provide reliable information in a cost-effective and efficient manner. Solid phase microextraction (SPME) is a versatile, non-exhaustive sample preparation tool that has been demonstrated to be well-suited for facile analysis of biological matrices such as plasma, blood, and tissue. In SPME, a small amount of extraction phase immobilized on a solid support is utilized for the extraction of analytes of interest, either from the sample headspace or by direct immersion of the fiber in the matrix of choice. For the analysis of non-volatile compounds in complex biological matrices, SPME coatings made of sorbents embedded in a biocompatible binder (e.g. polyacrylonitrile (PAN)) are directly immersed into the sample under study for a defined period of time so as to allow for sufficient and reproducible extraction of analytes. The main advantages of such coating materials rely on their ability to provide high selectivity for extraction of small molecules; their aptness for immobilization in different support geometries; their inertness and robustness, which even enables their reusability in complex biological matrices; and their suitability towards in vivo extractions. In view of these advantages, the body of this doctoral thesis presents novel applications and developments of SPME for both targeted and untargeted analysis of different biological matrices such as biofluids and brain tissue. The first part of the research conducted for this thesis encompasses the application of SPME in thin-film format for high throughput determination of multiple prohibited substances in plasma. A biocompatible SPME extraction phase made of hydrophilic-lipophilic balance (HLB) particles immobilized with PAN was employed for extractions, demonstrating satisfactory extraction capabilities for 25 compounds of a wide range of polarities (logP from -2 to 6.8). By taking full advantage of the 96 thin-film handling capability of the automated system, a preparation time of approximately 1.5 min per sample can be achieved. Rewarding results in terms of absolute matrix effects were found for the majority of the studied analytes, given that 24 out of 25 compounds exhibited values in the range 100 - 120%. The method was validated in terms of linearity (R2> 0.99), inter and intra-day accuracy (85 – 130%) and precision (< 20%), and limits of quantitation (0.25 – 10 ng mL-1 for most compounds). Based on the positive results obtained after employing the developed method for the analysis of doping compounds in plasma samples, and considering the need for cost-effective and single use devices, the possibility of employing alternative materials to manufacture SPME devices was explored. To that end, new thin-film SPME devices prepared on plastic as potential single-use samplers for bioanalysis were developed and tested. Polybutylene terephthalate (PBT) was selected as a support based on its chemical resistance, low cost, and suitability as a material for different medical grade components. The proposed devices were assessed in terms of robustness, chemical stability, and possible interferences upon exposure to different solvents and matrices. Satisfactory results were obtained upon utilization of the manufactured samplers for the quantitation of multiple drugs in biofluids such as urine, plasma, and whole blood. Interestingly, our results showed that more than 20 extractions in complex biofluids can be performed without incurring significant changes in coating performance. These findings evidenced the robustness of PAN-based coatings applied on polymeric substrates, and opened up opportunities for the introduction of new support materials for manufacture of SPME biocompatible devices aimed at a wide range of applications. Taking into account that SPME is a non-exhaustive extraction technique where analytes are extracted via free concentration, assessing the effect of variable matrix composition on final SPME recoveries is invaluable in avoiding biased results. With this in mind, part of this thesis also involved the investigation of the effect of hematocrit (Hct) levels on SPME extractions from whole blood. The obtained results demonstrated that the Hct effect in SPME is dependent on the analytes of interest, and that different outcomes can be attained by varying experimental conditions such as coating type, convection, and extraction time. Interestingly, the relative affinities of target compounds for matrix components and coating materials were demonstrated to be one of the main determining factors on the final effect that erythrocyte levels impart on SPME recoveries. Although Hct content was shown to affect the extraction of each analyte differently, and be dependent on experimental parameters, correction of matrix variability is enabled through the use of appropriate internal standards. In view of the rewarding results obtained in the analysis of a broad range of target analytes, SPME in its fibre configuration was evaluated based on its performance for untargeted analysis of brain tissue. For that purpose, the metabolite coverage provided by C18, mixed mode (MM), and HLB 7 mm fibres following extraction from brain homogenate at static conditions was assessed. Our results demonstrated that for compounds of medium to high polarity, both HLB and MM coatings were able to offer similar coverage at the same desorption conditions. For extraction of lipids, C18 and HLB exhibited the best recoveries with the use of 1:1 methanol:isopropyl alcohol as desorption solvent. Interestingly, the use of different desorption solvents was found to greatly influence the final composition of the brain extract obtained via SPME. Other parameters such as extraction time, coating washing step, and inter-fibre reproducibility were also considered and discussed. Lastly, the balanced metabolite coverage provided by SPME was successfully utilized for in vivo monitoring of metabolic changes occurring in the hippocampus of rat brain after electrical stimulation (DBS) of the ventromedial prefrontal cortex (vmPFC), which has been previously shown to induce anti-depressant like effects in rodents. The use of in vivo SPME enabled the monitoring of significant variations, not only among small polar metabolites such as amino acids, but also in lipids belonging to different classes. Compounds such as citrulline, glutamate, taurine, uric acid, sphingomyelins, and phosphatidylethanolamines, among others, exhibited statistically significant changes after acute exposure of animals to electrical stimulation for 3 hours. Although additional studies are needed to establish the contribution of the biochemical changes observed in this study to the effect of DBS in the treatment of depression, our work provided new directions towards a better understanding of the mechanisms taking place in the brain upon application of electrical stimulation to the vmPFC.
Cite this version of the work
Nathaly Reyes-Garcés (2017). Solid Phase Microextraction as a Sample Preparation Tool for Targeted and Untargeted Analysis of Biological Matrices. UWSpace. http://hdl.handle.net/10012/12457