Show simple item record

dc.contributor.authorMrabet, Nizar 16:33:39 (GMT) 16:33:39 (GMT)
dc.description.abstractRadio frequency power amplifiers (PAs) are the most challenging part of the design of radio systems since they dictate the overall system's performance in terms of power efficiency and distortion generation. The performance is further challenged by modern modulation schemes which are characterized by highly varying signal envelopes. In order to meet the spectrum mask requirements, PAs are usually operated at high power back-off to ensure linearity, at the cost of efficiency. To tackle this issue, many efficiency enhancement techniques have been presented in the literature. In fact, these techniques do increase the PA power efficiency at back-off, however, efficiency enhancement techniques do not ensure the linearity of the PA. Furthermore, these techniques may lead to additional distortion. On the other hand, several linearization techniques have been developed to mitigate the PA nonlinearity problem and allow the PA to operate at less back-off. Digital Pre-Distortion (DPD) technique is gaining more attention, as compared to other linearization techniques, thanks to its simple concept and advancements in digital signal processors (DSP) and signal converters. DPD technique consists of introducing a nonlinear function before the PA so that the overall cascaded system behaves linearly. It was clear from the literature that this technique showed good performance. Yet, it has primarily been validated using commercial test equipment, which has good capabilities, and far from the real world environment in which this technique would be implemented. Indeed, DPDs would need to be implemented in signal processors characterised by limited resources and computational accuracy. This thesis presents an implementation of several DPD models, namely look-up table (LUT), memoryless polynomial and memory polynomial (MP), on a field programmable gate array (FPGA). A novel model reformulation made this implementation possible in fixed-point arithmetic. Measurements were collected to validate the DPD models' implementation and an improvement of the signal quality was recorded in terms of error vector magnitude (EVM) and adjacent channel leakage ratio (ACLR). As many wireless access technologies must continue to coexist, multi-standard radio systems are required to reduce the cost while maintaining the interoperability. This thesis presents a development platform for multimode radio which comprises mixed-signal modules. The platform provides the capacity for hardware and software development. In fact, the FPGA under investigation allowed for the implementation of a baseband transceiver and DPD schemes. In addition, a software tool was developed as a dashboard to control and monitor the system. The radio system in the platform was optimized through the equalization of the feedback receiver frequency response performed through a simultaneous measurement of the amplitude ripple of the transmitter and receiver. Furthermore, a phase-coherent frequency synthesizer was designed to bring more flexibility by allowing the transmitter's carrier frequency to be different from the receiver's frequency.en
dc.publisherUniversity of Waterlooen
dc.subjectPower Amplifiersen
dc.subjectDigital Predistortionen
dc.titleMixed-Signal Multimode Radio Software/Hardware Development Platformen
dc.typeMaster Thesisen
dc.subject.programElectrical and Computer Engineeringen and Computer Engineeringen
uws-etd.degreeMaster of Applied Scienceen

Files in this item


This item appears in the following Collection(s)

Show simple item record


University of Waterloo Library
200 University Avenue West
Waterloo, Ontario, Canada N2L 3G1
519 888 4883

All items in UWSpace are protected by copyright, with all rights reserved.

DSpace software

Service outages