Show simple item record

dc.contributor.authorKabir, Salman
dc.date.accessioned2011-04-20 15:33:27 (GMT)
dc.date.available2011-04-20 15:33:27 (GMT)
dc.date.issued2011-04-20T15:33:27Z
dc.date.submitted2011
dc.identifier.urihttp://hdl.handle.net/10012/5849
dc.description.abstractInteractive handheld electronic displays use hydrogenated amorphous silicon (a-Si:H) thin film transistor (TFT) as a backplane and a Touch Screen Panel (TSP) on top as an input device. The low mobility and instability of a-Si:H TFT threshold voltage are major two issues for driving constant current as required for Active Matrix Organic Light Emitting Ddiode (AMOLED) displays. Low mobility is compensated by increasing transistor width or resorting to more expensive material TFTs. On the other hand, the ever increasing threshold voltage shift degrades the drain current under electrical operation causing OLED display to dim. Mutual capacitive TSP, the current cell phone standard, requires two layers of metals and a dielectric to be put in front of the display, further dimming the device and adding to visual noise due to sun reflection, not to mention increased integration cost and decreased yield. This thesis focuses on the aforementioned technological hurdles of a handheld electronic display by proposing a dual-gate TFT used as an OLED current driving TFT and a novel phase response readout scheme that can be applied to a one metal track TSP. Our dual-gate TFT has shown on average 20% increase in drive current over a single gate TFT fabricated in the same batch, attributed to the aid of a top channel to the convention bottom channel TFT. Furthermore the dual gate TFT shows three times the Poole-Frenkel current than the single gate TFT attributed to the increase in gate to drain overlap. The dual-gate TFT shows a 50% improvement in threshold voltage shift over a single gate TFT at room temperature, but only ~8% improvement under 75ºC. This is an important observation as it shows an accelerated threshold voltage shift in the dual-gate. This difference in the rate of threshold voltage change under varying temperature is attributed to the difference in interface states, supporting Libsch and Kanicki’s multi-level temperature dependant dielectric trapping model. The phase response TSP readout scheme requires IC only on one side of the display. Cadence Spectre simulation results showed that both touch occurrence and touch position can be obtained using only one metal layer.en
dc.language.isoenen
dc.publisherUniversity of Waterlooen
dc.subjectTFTen
dc.subjectDual Gateen
dc.subjectVt Shiften
dc.subjectLeakageen
dc.subjectPhase Responseen
dc.subjectTouch Screen Panelen
dc.subjectCharge Trappingen
dc.subjectDefect Creationen
dc.subjecta-Si:Hen
dc.subjectAMOLEDen
dc.titleAmorphous Silicon Dual Gate Thin Film Transistor & Phase Response Touch Screen Readout Scheme for Handheld Electronics Interactive AMOLED Displaysen
dc.typeMaster Thesisen
dc.pendingfalseen
dc.subject.programElectrical and Computer Engineeringen
uws-etd.degree.departmentElectrical and Computer Engineeringen
uws-etd.degreeMaster of Applied Scienceen
uws.typeOfResourceTexten
uws.peerReviewStatusUnrevieweden
uws.scholarLevelGraduateen


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record


UWSpace

University of Waterloo Library
200 University Avenue West
Waterloo, Ontario, Canada N2L 3G1
519 888 4883

All items in UWSpace are protected by copyright, with all rights reserved.

DSpace software

Service outages