Fahim, Amr Mohamed2006-07-282006-07-2820012001http://hdl.handle.net/10012/617The wireless market has experienced an exponential growth over the past few years. To sustain this growth along with the increasing demands of new wireless standards, the cost, battery lifetime, and performance of wireless devices must all be enhanced. With the advancement of radio frequency (RF) technology and requirement for more integration, new RF wireless architectures are needed. One of the most critical components in a wireless transceiver is the frequency synthesizer. It largely affects all three dimensions of a wireless transceiver design: cost, battery lifetime, and performance. In this thesis, new generations of RF synthesizer and transmitter architectures allowing low-power, high-performance and lower cost are presented. The common approach to frequency synthesis design for wireless communication is to design an analog-compensated fractional-N phase-locked loop (PLL). However, this technique suffers from lock time limitations and lack of adequate fractional spur suppression for third generation wireless standards. In this work, two new fast lock PLL architectures are reported to overcome the above mentioned limitations with the aid of digital signal processing. One such scheme makes use of modified digital sigma-delta modulator to completely randomize fractional spurs present in fractional-N PLLs as well as to reduce the level of phase noise produced by the sigma-delta modulator. This aids in fully integrating a high-performance PLL frequency synthesizer, and hence reducing cost. The use of this architecture for closed loop modulation is also examined. In another approach, a high frequency digital comparator aids in quickly acquiring frequency lock. Very fast lock times are achievable using this architecture. This architecture removes the PLL's frequency resolution dependence on the loop filter parameters. This helps to drastically reduce the size of the loop filter components, and enables them to be integrated on-chip. Although more suitable for low frequency resolution applications, such as wireless LAN and cordless, this architecture may be modified to obtain higher frequency resolutions. The major advantages of this architecture include low-cost, low-power, and a fully monolithic solution. Throughout this work, low-power has been achieved by both architectural techniques as well as circuit techniques. Architectural techniques enable tighter integration of the PLL's loop components on a single chip as well as faster lock time. Since the proposed techniques rely heavily on digital signal processing, low-power, high-performance digital logic families are reported. It is demonstrated how these logic families may be used in the frequency synthesizer architectures detailed above. Although differential in nature, it is demonstrated that the use of these logic families also helps to reduce area.application/pdf9119516 bytesapplication/pdfenCopyright: 2001, Fahim, Amr Mohamed. All rights reserved.Harvested from Collections CanadaDoctoral Thesis