The initial phase of a research and development program for the Consumers' Gas Co. and the Federal Department of Energy, Mines and Resources to design a condensing heat exchanger/gas fired residential air furnace has been ...

In cold climates the increased edge-glass heat transfer at the perimeter of a sealed glazing unit creates a special problem. This is where condensed water and frost most readily occur. One mechanism contributing to edge-glass ...

In cold climates the augmented edge-glass heat transfer at the bottom of a glazing system creates a special problem. This is where condensed water and/or frost most readily occur. Two mechanisms determining the rate of ...

Precise heat transfer measurements have been carried out during the last 20 years using a guarded heater plate apparatus. This apparatus has been adapted and used over the last several years to perform U-value measurements ...

The selection of optimum pane spacing for glazing systems has been a topic of ongoing debate in the window manufacturing industry. Arguments are often based on speculation, intuition and results from tests not specifically ...

Research is documented which makes use of a computer program called VISION, This computer program was developed specifically to provide a detailed analysis of heat transfer occurring in glazing systems. VISION was modified ...

Previous work has shown that highly infrared transparent plastic films are well suited for use as inner glazings when used in conjunction with a low emissivity coating. Thermal resistance measurements of a set of glazing ...

The existing design of glazing system edge-seals creates increased edge-glass heat transfer at the perimeter of sealed glazing units. This thermal short-circuit caused by edge-seal conduction results in added mechanical ...

Theoretical work has illustrated that highly infrared, transparent plastic films are well suited for use as intermediate glazings when used in conjunction with a low emissivity coating. Prototype glazing systems that ...