Browsing Engineering (Faculty of) by Type "Article"
Now showing items 21-40 of 589
-
Assessment of failure toughening mechanisms in continuous glass fiber thermoplastic laminates subjected to cyclic loading
(Elsevier, 2019-03-15)Tensile fatigue behaviour of glass fiber/polyamide composites, including unidirectional ([0]8, [90]8) and cross-ply ([02/902]s, [04/904]s and [904/04]s) laminates, was studied and compared to that of similar glass fiber/epoxy ... -
Assessment of Germanane Field-Effect Transistors for CMOS Technology
(Institute of Electrical and Electronics Engineers, 2017-10-13)Using self-consistent atomistic quantum transport simulations, the device characteristics of n-type and p-type germanane (GeH) field-effect transistors (FETs) are evaluated. While both devices exhibit near-identical off-state ... -
Assessment of High-Frequency Performance Limit of Black Phosphorus Field-Effect Transistors
(Institute of Electrical and Electronics Engineers, 2017-05-18)Recently gigahertz frequencies have been reported with black phosphorus (BP) field-effect transistors (FETs), yet the high-frequency performance limit has remained unexplored. Here we project the frequency limit of BP FETs ... -
Assessment of the thermomechanical performance of continuous glass fiber-reinforced thermoplastic laminates
(Elsevier, 2018-05-01)The effects of temperature on the static tensile behavior of continuous E-glass/polyamide laminates were studied in order to assess the feasibility of using the material system for structural applications. Uniaxial tensile ... -
An asymmetric elastic-plastic analysis of the load-controlled rotating bending test and its application in the fatigue life estimation of wrought magnesium AZ31B
(Elsevier, 2014-07-01)Due to different deformation mechanisms arising from limited slip systems in HCP wrought magnesium alloys, their yield and hardening in tension and compression are different. Consequently, the cyclic behavior of these ... -
Asymmetric Graetz Problem: The Analytical Solution Revisited
(American Institute of Aeronautics and Astronautics, 2017-01-01)Forced-convective heat transfer from the walls of an asymmetrically heated channel to the fluid passing through in a laminar, hydrodynamically developed flow is known as the asymmetric Graetz problem. Several analytical ... -
Augmented Reality-based Indoor Navigation: A Comparative Analysis of Handheld Devices vs. Google Glass
(IEEE, 2017-02)Navigation systems have been widely used in outdoor environments, but indoor navigation systems are still in early development stages. In this paper, we introduced an augmented-reality-based indoor navigation application ... -
Automated topology optimisation of hybrid electric vehicle powertrains
(Inderscience publishers, 2015-11-04)Gasoline and electric powertrain components can be connected in numerous configurations to create hybrid powertrains. Owing to the exponential increase of permutations as the number of components increases, a framework to ... -
Automatic feature selection and weighting for the formation of homogeneous groups for regional IDF estimation
(Elsevier, 2019-08)The intensity-duration frequency (IDF) curve has been used as an effective tool to quantify the risk associated with the impact of extreme rainfall on civil infrastructure. However, recent changes in the rainfall climatology ... -
A battery hardware-in-the-loop setup for concurrent design and evaluation of real-time optimal HEV power management controllers
(Inderscience publishers, 2013-11-03)We have developed a battery hardware-in-the-loop (HIL) setup, which can expedite the design and evaluation of power management controllers for hybrid electric vehicles (HEVs) in a novel cost- and time-effective manner. The ... -
Bayesian Filtering of Surface EMG for Accurate Simultaneous and Proportional Prosthetic Control
(Institute of Electrical and Electronics Engineers, 2016-12-01)The amplitude of the surface EMG (sEMG) is commonly estimated by rectification or other nonlinear transformations, followed by smoothing (low-pass linear filtering). Although computationally efficient, this approach leads ... -
Beluga Whale Detection in the Cumberland Sound Bay using Convolutional Neural Networks
(Taylor and Francis, 2021-03-29)The Cumberland Sound Beluga is a threatened population of belugas and the assessment of the population is done by a manual review of aerial surveys. The time-consuming and labour-intensive nature of this job motivates the ... -
Bi-objective short-term scheduling in a rolling horizon framework: a priori approaches with alternative operational objectives
(Elsevier, 2019-11)This study addresses short-term scheduling problems with throughput and make-span as conflicting objectives, focusing on a priori multi-objective methods. Two contributions are presented. The first contribution is to propose ... -
Bifunctionally active and durable hierarchically porous transition metal-based hybrid electrocatalyst for rechargeable metal-air batteries
(Elsevier, 2018-12-30)In this work, we show an effective strategy combining experimental and computational methods to explore and clarify rational design approaches utilizing transition metals for enhanced electrocatalysis of oxygen reactions. ... -
Bimodal grain microstructure development during hot compression of a cast-homogenized Mg-Zn-Zr alloy
(Elsevier, 2018-05-02)Hot deformation of a cast-homogenized ZK60 alloy was studied by compression at a temperature of 450 °C and a strain rate of 0.001 s−1 to investigate microstructural evolution. The deformed microstructure was characterized ... -
Binary vs. Ternary Reactivity Ratios: Appropriate Estimation Procedures with Terpolymerization Data
(Elsevier, 2018-08-01)There is a widely accepted analogy between copolymerization and terpolymerization mechanisms that has allowed researchers to use reactivity ratios obtained for binary pairs (from copolymerization experiments) in models ... -
Binary vs. ternary reactivity ratios: Appropriate estimation procedures with terpolymerization data
(Elsevier, 2018-08-01)There is a widely accepted analogy between copolymerization and terpolymerization mechanisms that has allowed researchers to use reactivity ratios obtained for binary pairs (from copolymerization experiments) in models ... -
Bioresourced fillers for rubber composite sustainability: current development and future opportunities
(Royal Society of Chemistry, 2021-06-18)Ending the fossil fuel era towards a sustainable future will require high-performing renewable materials with a low environmental impact. Carbon black, produced by partial combustion or thermal decomposition of petroleum ... -
Biotrickling Filtration of Air Contaminated with 1-Butanol
(Multidisciplinary Digital Publishing Institute, 2017-08-15)The removal of high concentrations of 1-butanol in an air stream was evaluated with a biotrickling filter for potential application to an industrial off-gas. Experiments were conducted on a laboratory-scale system, packed ... -
Bipolar resistive switching and memristive properties of hydrothermally synthesized TiO2 nanorod array: Effect of growth temperature
(Elsevier, 2018-08-05)In the present work, the hydrothermal approach is employed to develop 1D-TiO2 nanorod array memristive devices and the effect of hydrothermal growth temperature on TiO2 memristive devices is studied. X-ray diffraction (XRD) ...